IFAT München

We call back
Phone +49 40 790 185 0
info@dynainstruments.com

IFAT

The IFAT Munich will take place from Mai 4 - 7th 2026 in Munich.

Our distributor MEDON is looking forward to your visit at his stand!

Description
Technical Data
Downloads

The indicator DYNAguard P is used for monitoring the mass flow in solid material handling applications such as pneumatic transport lines, free fall pipes, chutes or hopper in a wide range of mass flow from g/h to t/h.

The meter detects moving electrical charges that are produced, for example, through friction with other objects such as the pipe wall and then naturally adhere to the solids surface solids, solid lining will not be detected.

The detection area goes some centimeters around the sensor plate so that nearby located moving components as e.g. flaps do not have any influence.

Due to the measuring principle also moving massive compact solids as plates or rods can be monitored.

The device is not applicable for solids which build up an electrical conducting layer on the sensor surface through friction or deposition.

Material	Housing	Stainl. steel1.4305 (ASIS 303)
	Sensor plate (standard)	Stainl. steel1.4571 (AISI 316 Ti)
	Isolation (standard)	Polyamid (PA)
	Sealing (standard)	NBR
Ambient cond.	Temperature	-20 °C ... +70 °C (-4 °F ... +158 °F)
	Degree of protection	IP 67 (EN 60529)
	EMC	According to EN 61326-1
Process cond.	Temperature	Max. +90 °C (+194 °F)
	Pressure	Max. 6 bar (84 lbs)
Output	DYNAguard P01	Relais: max. 48 V AC/DC, 1A
		High/low switchable
	DYNAguard P02	Transistor: galvanically isolated
		Max. 31 V DC, 15 mA
		High/low switchable
	DYNAguard P20	4 - 20 mA, galvanically isolated
		Load < 500 Ω
Supply voltage	DYNAguard P01/02	17 - 31 V DC, max. 60 mA
	DYNAguard P20	17 - 31 V DC, max. 90 mA
Adjustment	Sensitivity	1 - 180.000
	Damping	0 - 10 s (P01/02), 0 - 180 s (P20)
	Switchpoint	1 - 10 (DYNAguard P01/02)
	Zero set	4 mA (DYNAguard P20)